尊龙凯时人生就是博

±ê×¼¹âÄ £¿é

±ê׼ЭÒé¹âÄ £¿é

¼æÈÝЭÒé¹âÄ £¿é

ÆäËüÖÖÀà¹âÆ÷¼þ

ÊÖÒÕÖ§³Ö

200G-CFP2-DCO

200G-CFP2-DCO

1.0/5 rating 1 vote

Description

Product Description

100G/200G CFP2 DCO module is dual rate (100G/200G) Coherent Multi-Vendor MSA Compatible CFP2 (C (centum) Form Factor Pluggable 2) Transceiver designed for operation over Double Fiber optical cable. On the transmission side, the module converts 25.78Gbps (CAUI-4) or 27.95Gbps (OTL4.4) electrical input channels into one Single Lambda 100G/200G optical signal. Reversely the opposite is done on the receiving side, the module converts one Single Lambda 100G/200G optical signal into 25.78Gbps (CAUI-4) or 27.95Gbps (OTL4.4) electrical input signal. Module has a minimum guaranteed optical budget of 18.5 dB, which in most cases is enough to reach 80km without signal amplification, however the module can reach up to 2000km (100G) or 1000km (200G) with signal amplification. Distance is just an indicative parameter for comfort of identification that is calculated by taking into account minimal optical budget and average attenuation of optical cabling in industry. To achieve high data rate, long haul error-free transmission Soft Decision FEC (Forward Error Correction) with 25% overhead has been implemented on this unit. 200G Coherent CFP2-DCO has advanced DSP (Digital Signal Processor) ASIC and integrated Coherent Transmitter/Receiver which helps to revolutionize the IP routing F-tone Networks giving it ability to transport IP over DWDM Network (IPoDWDM). 200G Coherent CFP2-DCO Transmitter and Receivers support PM-DQPSK (polarization-multiplexed differential quadrature phase shift keying) / PM-QPSK (polarization-multiplexed quadrature phase shift keying) modulation for 100G and PM-16QAM (Polarization multiplexed 16-ary quadrature amplitude modulation) for 200G.

200G CFP2 DCO uses tunable DWDM Coherent laser transmitter (ITU-T 50Ghz C-Band 96 Channels) and tunable DWDM Coherent (ITU-T 50Ghz C-Band 96 Channels) receiver. 200G CFP2-DCO supports DDM/DOM optical diagnostics that provide real-time diagnostic information about the present operating conditions and additionally the module has built-in Line & Client PRBS (pseudorandom binary sequence) generator and checker which can help to diagnose and test the link state. 200G CFP2-DCO operates in Standard -5° to 70°C temperature range and has Double LC connector facing Line side and 104-pin CFP2 MSA-compliant connector towards Host side.

Key Technical Data
Media Type:

Single-Mode Fiber (SMF.)

Connectors:

Double LC

Supported Data Rate:

112.2 to 210.4 Gbps

Supported Applications:

200G Ethernet (212.5 Gbps), OTUC2 (210.4 Gbps), 100G Ethernet (103.125Gbps), OTU4 (112Gbps)

Modulation

16QAM (200G), DQPSK/QPSK (100G)

DDM/DOM:

Supported

Test Function:

Line & Client PRBS Generator and Checker

Forward Error Correction (FEC):

SD-FEC 25%

Minimum Optical Budget:

18.5 dB

Maximum Distance:

2000km (100G), 1000km (200G)

Transmitter Type:

Tunable DWDM Coherent

TX Wavelength:

Tunable 1529.16-1567.13nm

Tx Wavelength Bandwidth:

ITU 50Ghz C-Band Grid

Receiver Type:

Tunable DWDM Coherent

RX Wavelenght:

Tunable 1529.16-1567.13nm

Rx Wavelength Bandwidth:

ITU 50Ghz C-Band Grid

Average Launch Power (Min) Each Lane:

-10 dBm

Average Launch Power (Max) Each Lane:

1 dBm

Optimum Input Power (Min):

-14 dBm

Optimum Input Power (Max):

0 dBm

Extended Input Power (Min):

-18 dBm

Extended Input Power (Max):

0 dBm

Receiver Overload:

1 dBm

Temperature Range:

Standard -5° to 70°C

Storage Temperature:

-40° to 85°C

Relative Humidity:

0 to 85%

Power Consumption:

≤ 21W (100G) / 26W (200G)

Power:

+3.3V

Compliance:

CEI-28G-MR, CFP MSA Management Interface Specification 2.6 r06a, CFP2 MSA Hardware Specification Rev. 1.0, CMIS V4.0, OIF-CFP2-DCO, OTL4.4/OTLC2 Signaling, RoHS-6, CE

 

 

 

 

 

Important Notice

Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.

The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.

Search

sitemap¡¢ÍøÕ¾µØͼ